Build Your Own Bluebird House

Bluebird House

One of the most welcome signs of spring is the emergence of the cheerful bluebird. Three varieties for this colorful insectivore can be found in North America: the Eastern, the Western and the Mountain. Suffering a population reduction of nearly 90% in the 20th century, bluebirds have been unfortunate victims of deforestation, an increase in competition from starlings introduced to North America in the mid-1800s, and a marked increase in the use of insecticides. Although these problems continue, in the last few decades its numbers have stabilized and are now increasing, thanks, in part, to initiatives taken by bird lovers and gardeners through the construction of bluebird houses.

Easy to build, these DIY shelters can be constructed from scrap lumber. Assembled with specific dimensions designed to replace the natural hollows and cavities found in mature trees, a homemade bluebird house will provide a safe location for bluebirds to nest and hatch their eggs. Mounted along the perimeter of open fields, gardens or large lawns, they provide ideal housing for bluebirds that may otherwise struggle to locate natural shelter and easy access to insects on which to feed.

Introducing subsidized housing for these tiny songbirds provides more than just a feather in your conservational cap. Not only are bluebirds a treat for the eyes and ears, they do a great job of keeping insects at bay. This is a DIY project that will pay off all summer long.

advertisement

Step 1

 Open Gallery

Buy or source a  5’ x 5 1/2” x 3/4” plank of untreated wood. Pine or cedar are excellent choices, but any untreated wood will do.

Step 2

 Open GalleryCut to size

Measure and cut wood to the following dimensions. Mark and cut each piece before continuing to the next.

 Cut List

One 14” x 5 1/2” (back)

Two 9” x 5 1/2” (sides)

One 7” x 5 1/2” (roof)

One 4” x 4 3/4” (bottom)

One 9” x 4” (front)

Step 3

 Open GallerySand

Once all pieces are cut, lightly sand any rough edges.

Step 4

 Open Gallery

Assemble back, sides, roof, and bottom using nails. Sides should be flush with the base of the bluebird house. Back should hang about an inch below the bottom. A clamp in not necessary, but can be helpful for keeping edges straight during assembly.

Step 5

 Open Gallery

Drill a 1 1/2” entrance hole in the front panel centered from the sides and the top of the hole approximately 1 3/4” from the top.

Step 6

 Open Gallery

Place the front on the box, leaving a 1/4” gap between the top of the front and the roof. This gap will allow the front to pivot open and also provides necessary ventilation.

Step 7

 Open GalleryAttach door

Secure the front to the house with a single nail on each side 1/2” from the top.

Step 8

 Open GalleryPivot

Make sure the front pivots easily. This panel allows easy access for observation and cleaning.

Step 9

 Open Gallery

Drill a small hole at the top or bottom edge of the back for easy mounting.

Step 10

 Open GalleryPaint

Painting is not necessary, but light color paint may be applied (dark colors will draw unwanted heat to the nest). Do not paint the interior of the box.

Step 11

 Open GalleryDoor catch

Attach a small pivoting catch at the bottom edge of the door to keep it from swinging open. A bent nail will work. Here we have used a tack intended for securing electrical wires.

Step 12

 Open GallerySelect site

Mount the box at a height of at least five feet near open land, but within 100 feet of shrubs, trees or other locations where birds may perch. Multiple boxes are encouraged at distances of 50 to 100 yards.

Materials

  • 5’ x 5 1/2” x 3/4” plank of untreated wood
  • Nails
  • Paint (optional)

Tools

  • Tape measure
  • Hand or miter saw
  • Sandpaper
  • Hammer
  • Drill with 1 1/2″ and 1/4″ bits
  • Bar clamps (optional)
About Mick Telkamp 

33Posts

A former Midwesterner living in North Carolina, I write about my adventures in backyard chicken-keeping and suburban homesteading over at HGTVGardens, and my exploits in the culture of Southern cooking ...

More About Mick Telkamp
Leave a Reply

More Posts Like This One

Latest Pins on Pinterest

  • Go behind the scenes

    Go behind the scenes with Daryl Hall on his

  • Grundy being Grundy.

    Grundy being Grundy.

  • Grundy and Jason did

    Grundy and Jason did a great job on the living

  • Cuteness overload.

    Cuteness overload.

More Great Blogs